RFI 8-12dBi 3G+4G+4GX LPDA Antenna​

SKU: LPDA7030-11

Key Features

Solid construction for maximum performance and reliability

Integrated bracket for poles 25-60mm

Your choice of cable length and connector (SMA or N-type)

Wide spectrum design, suits all current and planned cellular networks (including 700MHz LTE).

Additional Information

The true brilliance of this engineering masterpiece is its extremely wideband design – operating on two extremely wide bands 694-1000MHz and 1500-3000MHz. Coupled with its robust durable construction, this log periodic dipole array (LPDA) antenna will stand up to the challenge of the ever-changing network of frequencies for years to come.

Usage

Not sure if you’ll get 4G? With an equally high gain on all other 2G/3G networks, you can still improve your current connection. With the Telstra 4G network expanding to cover 60% of Australia’s population in 2013 this is an antenna you can buy with the reassurance of future compatibility. Take full advantage of the blistering fast speed the Telstra 4G network offers. If you’re outside the official 4G ‘coverage zone’ or your modem keeps switching back over to Next-G, this antenna will help you lock on, or increase the signal strength and speed of your 4G connection.

Better for hilly areas

Lower gain Yagi antennas are ideal for areas where hills are very close to your location (within about 2km). Hills create a multipath environment – transmissions that bounce off trees or terrain at an acute angle cause signal echos. Having travelled a further distance than a straight line transmission these signals are delayed, and to a simple receiver would be nothing more than interference. However, thanks to clever technology used in cellular communications, multipath signals can recovered by your modem’s RAKE combiner (or with cyclic prefix for OFDMA based systems). A RAKE receiver consists of a series of sub-radios which read the incoming signal at different delay periods (typically one chip in WCDMA) and then combined to result in a higher quality signal. This antenna rests at ground potential, providing improved lightning protection and reduced precipitation static noise.

Termination is via your choice of an ‘N’ female coaxial connector fitted to a short LMR195 cable tail, or SMA male connector fitted to a 10 metre low loss LMR195 cable. We recommend the use of LMR400 grade cable when using this antenna on 4G due to it’s high frequency

Scroll to Top